Deeper patterns may require back-up strips to support the liner and are noted in the pattern details given in this catalog.

The dimensions given are nominal. Temperature changes can cause the liner to expand or contract and should be considered during design and installation.

Liners will become more rigid at temperatures below 25°F and should be handled carefully under such conditions.

Liners are UV stabilized, but should not be exposed to direct sunlight for prolonged periods.

Liners should not be used if concrete temperatures will exceed 140°F or in precast applications employing heated beds.

Type 3 concrete with accelerators creates high heat, which can cause damage to the liner.

Form Release 7000 is recommended for all liner grades. It is not required for Single-use liners, but the appearance of the concrete will benefit from an application of the release agent.

Use a single concrete supplier for uniformity and place the concrete with an elephant trunk to minimize aggregate segregation. Vibrate the concrete to eliminate lift lines and to minimize voids.

Clean the liner between casting with a mild detergent and brush and reapply the release agent before each pour.

Most form liners are manufactured to order and can not be returned or exchanged.

Interested in this item or want more information?
Call Mon. through Fri. 7:30 AM - 4:00 PM PST
Phone: (415) 822-4334
Email: Jon@LevelSupply.com

Can't find what you want? Give us a call and we can help you find it.

Additional Information

Manufacturer: Vinylex

For More Information on the Block and Brick Designs Form Liners, [Click Here] to Link to Manufacturer Web Site